Initial Setup; Before You Begin - Emerson LC320EM1 Manual Del Propietário

Ocultar thumbs Ver también para LC320EM1:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

These operations are accessible by remote control.
Some may also be accessible by controls on the main unit.

Initial Setup

This section will guide you through the unit's initial setting
which includes selecting a language for your on-screen menu
and autoprogram, which automatically scans and memorizes
viewable channels.

Before you begin:

Make sure the unit is connected to antenna or cable.
1
After making all the necessary connections,
press
to turn on the unit.
• It may take a few moments to turn on the unit for the
first time.
• [Initial Setup] menu appears automatically after the
unit is turned on.
2
Use ▲/▼ to select the on-screen language from the
choices (English / Español / Français) on the right side of the
TV screen.
3
Use ▲/▼ to select [Antenna] for TV channels or [Cable]
for CATV channels, then press OK.
Initial Setup
Make sure the antenna is connected to ''ANT. IN'' jack.
Select your signal source.
Antenna
Or
Cable
Select
OK
• [Autoprogram] will begin.
Initial Setup
Please wait while the system is scanning for channels.
Auto programming may take more than 20 minutes to complete.
0%
Digital channels
Analog channels
Antenna
Cable
Skip
ANT.IN
Back
Skip
0 ch
0 ch
Skip
4
Use ◄/► to select the desired location setting, then
press OK.
Initial Setup
Select "Retail" or "Home" for your location.
Retail
Select
• Select [Retail] store, the unit will be set up with
predefined setting for retail displays. In this setting, the
power consumption may possibly exceed the limited
requirement of the ENERGY STAR
• Select [Home], the unit is set to maximize the energy
efficiency for home setting and it can be adjusted
through a choice of picture and sound quality according
to your preference.
• When the initial setup is completed, the lowest
memorized channel with the confirmation message of
the location setting will be displayed on the TV screen.
Note
If you are not receiving a signal from your cable service, contact the Cable
provider.
or MENU during autoprogram, this setting will be canceled.
If you press
The initial autoprogram function can be executed for either [Antenna] or
[Cable] only once. When you change the connection (Antenna / Cable),
set [Autoprogram] again.
p. 19
If there is no signal input from the antenna terminal and no operation for
several seconds after you turn on the unit, [Helpful Hints] appears. Follow
the instructions listed on the TV screen.
Initial Setup
No channel is registered.
Try Autoprogram again?
Verify that you have a cable connected to the "ANT. IN" jack on the
back of the TV, the channel installation process searches this
connection. If you are using a cable or satellite box, please confirm the
input which you have connected the box and press "SOURCE" key on
the remote control to select the appropriate source input.
Select
You must set [Home] in step 4. Otherwise, the settings of picture and
sound quality you adjusted will not be memorized after you turn off the
unit.
After an initial setup is completed...
• If you want to scan the channels automatically again.
[Autoprogram]
• You can add the desired cable and analog channels
unmemorized by autoprogram.
[Add Channels]
• If you want to change to another language.
[Language Selection]
• If you want to change the location setting.
[Location]
English
Home
OK
R R qualification.
®
Retry
Later
OK
Skip
p. 19
p. 20
p. 21
p. 30
15
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lc260em1

Tabla de contenido