Beper RI.063 Manual De Instrucciones página 14

Wall-mounted fan heater with ceramic elements Use instructions
• Do not allow water and / or other liquids to enter the product.
• Do not install the product near possible splashes of water (shower,
sink ...)
• If the cable is damaged, contact the service centre immediately.
• This product is for home use only.
• Do not use the product with the knotted power cord.
• Do not turn off the product by pulling the power cord but use the
appropriate button.
• Disconnect the electrical outlet when the product is not in use.
• Do not allow the power cord to come into contact with hot surfaces.
• Do not store the product in closed spaces until it has completely
cooled down.
• Do not connect to external timers.
• Do not install the product outdoors.
• Place the appliance on a flat and stable surface.
• The product is equipped with an overheating protection system,
which will automatically block the operation of the product if it will be-
come too hot. So if the product should stop suddenly it is advisable to
turn it off and let it cool down for a few minutes, then turn it on again.
If the product does not light up again, contact the assistance.
PRODUCT INSTALLATION: Fig.1
Attention: Before fixing the product to the wall, make sure that there are no electric wires, water
pipes or similar, in the area where the wall is to be drilled.
Before releasing the product make sure it is well secured to the wall.
Make two holes in the wall about 2 meters above the floor.
Leave at least 25 mm from the corners.
Make the holes large enough to allow the screws to pass through, but not too large to prevent them
from performing their function.
Fix two screws and wall plugs, the screw head must protrude 10mm, hold the product until the
screws are perfectly fixed.
PUT IN OPERATION:
1. Once the product is installed, connect it to the electrical outlet.
2. Set the main switch on the side of the product, to the ON position, you will hear a light "BIP" and
the light on the control panel will light up. The temperature set is 20 ° C.
3. Activate the remote control by removing the protective film located near the battery compartment.
14