Time Setting - Beper RI.063 Manual De Instrucciones

EN
Wall-mounted fan heater with ceramic elements Use instructions

TIME SETTING:

Set the time before switching on the product.
Press the "Lock" button on the remote control, the control panel will light up 00:00 and "Mo"
HOUR: press "SET" and "00" on the display will begin to flash. Use the "+ / -" keys to set the correct
hour.
MINUTES: press "SET" and "00" on the display will start to flash. Use the "+ / -" keys to set the
correct minutes.
DAY OF THE WEEK: press "SET" and "MO" on the display will start to flash. Use the "+ / -" keys to
set the correct day of the week. The days are indicated with the first two initials of the days in English:
MO = Monday - TU = Tuesday - WE = Wednesday - TH = Thursday - FR = Friday - SA = Saturday
- SU = Sunday
Attention: once the "SET" key is pressed, the selection will flash for 5 seconds and then return to
the initial selection.
The product retains the settings only if the product is turned off with the remote control. If the elec-
tricity fails, the power cable is disconnected or the main switch is turned off, the product must be set
again.
OPERATION:
Turn the product on with the ON / OFF button, the product will start to release cold air and the " "
light will light up on the control panel.
Press the button "MODE" on the remote control, warm air will come out and the " " and " " lights
will light up simultaneously.
Press the button "MODE" a second time, hot air will come out and the and lights will light up at
the same time.
Press the button "MODE" a third time, cold air will come out and the "Fan / M" will light on.
Attention: If you press the button on the control panel, once cold air comes out, twice warm air,
three times hot air, four times the "swing" function will be activated, five times the product will switch
off.
TIMER SETTING (24 HOURS)
Switch the appliance on (in one of the following modes: fan, warm, hot).
The button on the control panel and "24H" on the remote control have the same function.
Press the button " " to set the timer, while continuing to press the button It will be possible to
increase the hours from 00 to 24 and the "D" light will light up.
Warning: if you set "00" it means that no timer will be active and the "D" light will be off.
HOW OPERATE THERMOSTAT
Switch the appliance on (in one of the following modes: fan, warm, hot).
This function can only be activated with the remote control.
Set the temperature using the "+/-" keys. The temperatures available are from 10 ° C to 49 ° C. At
this point the " " indicator will light up.
When the temperature drops two degrees from the set temperature, the appliance will start to heat
again with "I / W" (1000W).
When the temperature drops four degrees from the set temperature, the appliance will start to heat
again with "II / W" (2000W).
When the temperature is higher than 1 degree or the same as the one set, the appliance will blow
cold air.
15