Cedes cegard Instrucciones De Montaje página 6

cegard/Mini
Please observe the following mounting guidelines:
Tx
T x
Oth er lig ht sou rces
Receiver (Rx) =
Blue connector
6
40°
40°
Rx Rx
☺
> 1 00'000 lu x
Rx T x
O ther ligh t sources
Emitter (Tx) =
White connector
Installation and Operation Manual
Never scratch or paint the optical lenses because they
form the light path! Do not drill additional holes into the
profile. Unpack them just before installation in order to
avoid damage!
The surface with the opto elememnts of the emitter and
the receiver should point to each other face-to-face!
Align the optical axis of the emitter and the receiver as
close as possible in order to achieve best performance
(±20° @ 2 m distance)!
Do not bend or twist the edges!
Oil may damage the cable. Contamination must there-
fore be avoided at all times!
Tx Even if cegard/Mini is not affected by direct sunlight, it's
better to avoid it.
Avoid external light from other infrared light sources like
photo eyes or light barriers!
Rx
For installation of opto edges please note:
Exit both cables, emitter and receiver, the same di-
rection
Do not bend the cables or expose them to tension
Ensure cables are kept as far as possible away
from AC mains or high voltages
Do not force, stretch or squeeze the cables
Ensure that the cable is well fastened and routed
Avoid soiling of opto edges
Avoid contamination by oil or greasy liquids
Avoid obstruction from door wings, cables etc. in the
protective area
www.cedes.com © CEDES/December 2008