Time And Date Adjustment - Italiana Camini PRIMA Instalación Uso Y Mantenimiento

AUGER LOADING (only in the event the stove is completely without pellets)
To load the auger enter the MENU, press the
load" appears.
Press the key to confi rm and then press the
This operation must only be carried out with the stove off and completely cold.
Note: during this phase the smoke extractor will stay on.
STAND-BY FUNCTION
This function, managed automatically, allows the stove to be switched off on surpassing 0.5 °C of the ambient temperature re-
quired, after a preset time of 10 minutes (which can be modifi ed by the TSC during the installation phase).
On the display the writing "GO STBY" appears indicating the remaining minutes to switch off.
This function is present in 'AUTOMATIC' functioning and in the event of an external thermostat.
If the ambient temperature lowers by 2 °C under the threshold set, the stove re-starts (this can be modifi ed by the TSC during the
installation phase).
To activate the function, press the
until you see the writing "M4 stand by" on the display, to confi rm press the
Press the key to select "ON" , to confi rm press the
To exit the "M4 stand by" menu, press the

TIME AND DATE ADJUSTMENT

Press the key for around 2 seconds, the writing "M1 set clock", will appear, to confi rm press the
The following data appear in sequence. Day of the week, hour, minutes, day, month and year
which can be changed, press the
To exit the "M1 set clock" menu, press the
EXTERNAL THERMOSTAT
It must be connected via the blue wire (optional code 640560) to the serial port positioned on the rear of the stove. There must be
clean, normally open contact (e.g. for an ambient thermostat):
- Contact open = Ambient temperature reached
- Contact closed = Ambient temperature not reached
To select 'T-E' (external thermostat) mode, press the
ture until the writing 'T-E' (external thermostat) appears on the display (under 6°).
Note: With the stove off, the external thermostat cannot in any case switch on or off the stove. If you want to switch off or
on the stove outside the chrono time or the 'T-E' (external thermostat) setting, you always need to use the
CHRONOTHERMOSTAT FOR DAILY/WEEKLY PROGRAMMING
Three programming modes are planned (daily, weekly and weekend), each of which is independent from the other and thereby al-
lows multiple combinations according to personal requirements (you can adjust the hours in 10 minute steps).
Press the key for 2 seconds. The writing "M1 set clock" appears on the display (the led switches on).
Press the key until the writing "M2 set chrono" appears on the display, to confi rm press the
To display the 3 programming modes (daily, weekly, weekend) press the
INSTRUCTIONS FOR USE
key for 2 seconds, press the
key to activate the function.
key for around 3 seconds, the writing "M1 set clock" will appear on the display, press the key
key.
key for approx. 6 seconds.
key or key. To confi rm press the
key for approx. 6 seconds.
key (the led switches on). Press the
- 116
key until the writing on the display "M5 fi rst
key.
key.
key or the key.
-
key.
key to decrease the tempera-
key.
key.