Digital Effect Processor; Usb Recorder - Phonic Powerpod 620 R Manual Del Usuario

Digital Effect Processor

21. Effects On Button (Powerpods, 740R only)
Pushing this button will turn the built-in effect processor on and off.
22. Program Control
This control will allow users to select one of the 16 built-in digital
effects of the Powerpod powered mixer. The effect names that
correspond with the numbers can be found above this control, or
details can be found in the digital effect table.
23. Parameter Control
Turning this control will adjust the one main parameter of the
selected effect. Each effect's parameter can be found on the digital
effect table at the end of this manual.
21

USB Recorder

The USB Recorder's source signal is taken directly from the main
mix prior to it being cut/boosted by the Main level control. While
the recordings are indeed in stereo, they are also limited by the
Powerpod 620 R and Powerpod 740 R's circuitry, which is dual-
mono rather than stereo. When playing back a signal, the signal
will pass through the USB trim control and then is sent directly to
the main mix. Playback of WAV and MP3 with bit rates of up to 320
kbits per second is possible.
24. Display
This 3-digit display will display the track number currently being
played. It also offers play, pause and record indicators to the left
of the display. When in playback mode, the screen will indicate the
type of file type the unit is currently playing: WAV or MP3.
25. USB Port
Connect your USB flash drive to this input. Once a drive is
connected, the files will initiate and the first track will appear paused
on screen.
26. Record Button
Push this button to start recording mode. When recording mode
is initiated, the next available track number (after any previously
recorded tracks) will appear on screen and recording mode will be
initiated in pause. Push the Play/Pause button to start recording.
Recording is only possible when an appropriate USB memory card
is inserted into the USB port.
27. Back/Next Buttons
Pushing these buttons will allow users to skip back and forwards
between tracks in sequence. Please note that these buttons cannot
be held down to fast-forward/rewind through tracks.
26
25
8
22
23
27
28
24
28. Play/Pause Button
Push this button to start and stop playback and recording of the
currently displayed track. Starting a track after it is paused will
resume the track from the point at which it was paused (in both
record and playback mode). When in recording mode, push and
hold this button to finalize recordings. When in playback mode,
pushing and holding this button will revert back to the first track on
the USB memory stick.
29. USB Trim Control
This level control adjusts the playback level
sent from the USB recorder's playback function
to the main mix. Users are advised to format
their USB memory sticks with the FAT-32 file
system.
Master Section
30. EFX to Monitor Control
This controls the level of the processed signal from the built-in effect
processor that is sent to the Monitor mix.
31. EFX to Main Control
This controls the level of the processed signal from the built-in effect
processor that is sent to the Main 1/2 mix.
32. AUX In Control
The AUX in control adjusts the final level of the AUX input that is
sent to the Main mix.
33. Tape In Control
The Powerpod 620 R features a Tape In control that adjusts the
final level of the RCA Tape input that is sent to the Main mix. The
Powerpod 740 R features two such controls, one underneath each
of its equalizers; the uppermost control adjusts the Tape input signal
sent to the Monitor mix, whereas the lower control adjusts the signal
sent to the Main mix.
34. Graphic Equalizers
These graphic equalizers allow you to adjust the frequency response
of a signal, with a maximum of ±12 dB of signal boost or cut for
each of the frequencies. The Powepods 740 R features dual 7-band
graphic equalizers, while the Powerpod 620 R features a single
stereo 7-band graphic equalizer for both the Main and Monitor
signals. The uppermost equalizer is for alteration of the Monitor
signal (when the EQ switch is in the appropriate position it becomes
the Main 2 EQ), where the lower equalizer is for the Main signal
(or the Main 1).
30
31
POWERPOD 620 R / POWERPOD 740 R
36
32 33
29
34
35