Picture-In-Picture (Pip) Operation - Sanyo DS31810 Manual Del Propietário

QuickTips
PIP window is black
with no picture:
1. Check cable
connections.
2. Make sure VCR is
turned on.
3. Select another
channel on your
VCR.
Same picture appears
in Big and Small
windows. Set VCR
to TV mode.
To view two TV
programs or watch
a TV program and
prerecorded tape at
the same time, follow
steps on this page and
chart on page 15.
PIP KEYS
Use the SWAP key to
exchange programs
between the windows.
Use the LOCATION
key to change the
position of the small
window (Top: L /R or
Bottom: L /R).
Use the
FREEZE
key to stop the
action.
Use the SELECT key
to choose the PIP
video source (Video1,
Video2, or TV RF
Signal).
Need help?
Visit our website at
www.sanyoctv.com
or
Call 1-800-877-5032
14

PICTURE-IN-PICTURE (PIP) OPERATION

For PIP to function you must connect two signals to the TV. (Use the TV's 75 ohm input and
A/V inputs.) Connect VCR (or other accessory equipped with a video output jack) to the
TV's audio video jacks as shown on page 12. If you are using a satellite dish, you must
connect a cable system or antenna with the satellite to use the PIP feature (see page 13).
For operation with Cable Box, see chart on page 15.
USING PIP TO VIEW TWO TV PROGRAMS
Note: The following steps correspond to numbers on the Remote Control art below.
1. Switch VCR and television ON.
2. Press PIP ON/OFF key.
Set VCR to TV mode, if necessary.
3. Select channel for big window.
4. Press SELECT key to select Video1 or Video2 screen.
5. Press VCR key.
Note: If the remote control cannot be programmed to operate
your VCR, you must use the VCR's remote to perform VCR functions.
6. Select channel on VCR for small window.
USING PIP TO VIEW TV PROGRAM
AND PRERECORDED TAPE
Note: The following steps do not have corresponding
reference numbers on the remote control art.
1. Set TV channel to match output of VCR
(Channel 3 or 4).
2. Insert prerecorded tape into VCR.
3. Press PLAY, if necessary (wait for tape to load).
4. Set VCR to TV mode.
Note: When the remote control is in the VCR mode, the
INPUT/TV•VCR key works like the TV/VCR key
on the VCR.
VCR set to VCR mode.
Same image appears in
both windows.
5. Press SWAP key to view PIP image in big window.
VCR set to TV mode.
Different images appear
in each window.
VCR TV DVD
AUX
AS