Fermax iLOFT DUOX Manual De Instalador página 39

iL iL iL iL iLOFT DUO iL iL iL iL iLOFT DUO OFT DUO OFT DUOX X X X X OFT DUO OFT DUO OFT DUO OFT DUO OFT DUOX X X X X
OFT DUO
The monitor will automatically connect with the entry panel, activating the camera. Enter the
calling code for this monitor from the panel. Depending on the type of panel installed:
- pressing the corresponding button or
- by entering the code + bell.
Notes:
- The time from which you hear the monitor's confirmation beep for entering in monitor
programming, and the call is made from the panel to program the monitor's address,
must be less than 2 and half minutes.
- Programming is always done from the panel activated as the master panel.
2222
A different call tone is produced, confirming the monitor's programming and the camera's image
is still viewed. After a few seconds the monitor returns to standby. Once the monitor's address is
programmed it is indicated via a fixed red light.
Option 2: From the Monitor Monitors can be programmed on the screen menu.
Program the call number: Pressü on the previous screen and access the screen to program
the residence's number (numbers from right to left).
Each time the + is pressed the number increases (starting with 1) and the arrow is used for
moving the cursor. A white cursor indicates where the digit will be entered. Program the
corresponding number and accept with . Once the monitor's address is programmed it is
indicated via a fixed red light.
Page 13