Manual Activation Of The Monitor (Auto-Start) - Fermax iLOFT DUOX Manual De Instalador

iL iL iL iL iLOFT DUO iL iL iL iL iLOFT DUO OFT DUO OFT DUOX X X X X OFT DUO OFT DUOX X X X X OFT DUO OFT DUO OFT DUO
OFT DUO
Notes:
- Auto-start can only be done with the indicated panels. If you can not perform the auto-start,
ask your installer. Upon unsuccessfully completing the connection attempts with each of the
three possible panels, the monitor will issue an error tone and return to standby.
- After completing any communication with a panel, for the following 15 seconds if you re-press
the auto-start button it will connect with this panel.
To auto -start, with the camera displayed on the contextual menu, upon pressing the
corresponding button. Panel 1 of the block where the monitor is installed.
Note: The contextual menu sequences the cameras as the presses are made.
Manual Monitor Activation (Auto-Start)
With the monitor on standby, press and hold this button
monitor on manually.
the monitor (if applicable). If there is no monitor, the auto-start is activated
on panel 1 of the same block, and if there is none, communication is
established with the configured panel, like 0 of the General Entrance.
Once having established communication with a panel, you can change
the same one via the displayed contextual menu, (pressing the
corresponding pushbutton):
- button 0: Panel 0 Camera of the block where the monitor is installed.
- button 1: Panel 1 Camera of the block where the monitor is installed.
- button G: Panel 0 camera of the General Entrance.
(camera), to switch the
The image is viewed on the indicated
camera. Panel 0 of the block where the
monitor is installed.
Page 25