Hose Hook-Up & Inlets - Cyclo Vac GS 70 Manual De Instrucciones

BEFORE OPERATING YOUR CENTRAL VACUUM...
Please verify that it is properly connected to the piping system, and to a grounded
electrical outlet, and that the low voltage wires are connected to the unit (see
pages 8 to 16). Then read the complete owner's manual and proceed with a quick
verification of your installation:
works properly.
check other inlets for leaks.
To start your central vacuum, simply insert the hose in the vacuum inlet of your
choice. Please ensure that the tab on the hose end is properly lined up with the slot
in the inlet opening (figure 4). If your hose handle has an integrated on/off switch,
simply slide the switch to the "on" position.
Do not try to open another inlet while your system is in operation, as it
may damage the inlet's rubber seal.
HOSE HOOK-UP & INLETS
figure 4
Operating Instructions 9