Led Displays On The Flash Unit; Flash Readiness Indication; Correct Exposure Indication; Information In Display - Metz MECABLITZ 50 AF-1 digital Manual De Instrucciones

4 LED displays on the flash unit

4.1 Flash readiness indication

When the flash capacitor is charged, the flash readi-
ness symbol
ting that the flash is ready to fire. This means that flash
✴
light can be used for the next shot. Flash readiness is
also transmitted to the camera and indicated accor-
dingly in the camera's viewfinder (see 6).
If a shot is taken before the flash readiness indicator
appears in the camera's viewfinder, then the flash unit will not be triggered and,
if the camera has already switched to flash sync speed (see 11.1), the shot may
have the wrong exposure.

4.2 Correct exposure indication

The correct exposure indication „OK" only lights up for
about 5 seconds if the shot was correctly exposed in
TTL flash mode (
✴
If no „OK" exposure indication appears after the shot,
then the shot was underexposed. You will need to repe-
at the shot with the next smaller f-number (for example,
f/8 instead of f/11) or the distance to the subject or reflecting surface (for
example, with bounce flash) will have to be reduced. Note the maximum flash
range indicated on the display of the flash unit (see 5.2).
86
lights up on the flash unit, indica-
TTL TTL
, HSS; see 7)!

5 Information in Display

The cameras transmit the settings for ISO, lens focal length (mm) and aperture
to the flash unit. It calculates the maximum flash range from the settings and
their guide number. Flash mode, range and zoom position of the main reflector
are displayed in the display of the flash unit.
If the flash unit is operated without having received data from the camera, only
the flash mode selected, the zoom position of the main reflector and „Zoom" is
displayed. The display for range only occur once the flash unit has received the
data required from the camera.
☞ Auto-Zoom and flash range are only displayed on cameras where the
aperture and ISO values are transmitted to the flash unit!
Display illumination
Every time a button on the flash unit is pressed, the flash display illumination is
activated for 10 seconds. When a flash is fired via the camera or the hand
release on the flash unit, the display illumination is switched off.

5.1 Display of the flash mode

The current flash mode is shown in the
display. Depending on the type of camera,
different displays are available for the selected TTL
TTL TTL
flash mode (e.g., , HSS) and the manual flash
mode M (see 7).
TTL
TTL
F 5,6
7,5 105
m mm
Zoom