Operating Instruction - Trueshopping SFGT00B3SA Manual De Instrucciones

OPERATING INSTRUCTIONS
WARNING: Read and thoroughly understand all instructions and safety information before
operating this string trimmer. Failure to do so may cause serious injury or death. Do not allow
anyone to operate this string trimmer who has not read this manual. a string trimmer can be
dangerous if assembled or used improperly. Do not operate this string trimmer if you have doubts or
questions concerning safe operation. Call our customer service department at 0333 320 7794 to address
these concerns.
STARTING/STOPPING THE STRING TRIMMER
➢ Install the battery pack. (Refer to Installing the battery pack)
➢ Depress the lock off button (1) and at the same time press the
trigger switch (2). (See fig. 8)
➢ To switch off, release the trigger switch.
WARNING:
The tool runs for approximately 4 seconds after it has been switched off. Let the motor come
to a complete standstill before setting the tool down.
TRIMMING
WARNING:
Make sure that the work area is free of rocks, debris, lines and other foreign objects.
1. Start the trimmer before approaching the grass to be cut.
2. Stop the trimmer and check the line has fully extended and has been trimmed by the line cutting blade.
If the line is short restart the line trimmer.
Note: Each time the trimmer is stopped and restarted the line will release and extend by approx. 10mm.
3. Cut the grass by swinging the trimmer from right to left and proceed slowly keeping the trimmer
inclined forwards at an angle of about 30º light cuts are better than heavy cuts as they allow the cut
grass to fall away from the spool, preventing the grass from clogging the spool.
4. High grass should be cut in layers always beginning from the top. Do not cut damp or wet grass. Do
not overload your trimmer.
5. Avoid wearing the line out quickly by cutting against hard objects (stones, walks, fences etc.)
6. Watch out for kickbacks in the event of impact with hard objects.
7. After finishing the cutting operation, keep the head close to ground level, release the switch and allow
the motor to come to complete standstill. Place the trimmer on the ground and remove the battery pack
from the trimmer.
Note: Periodically clean out the grass between the spool and the rim of the guard to prevent the tool from
vibrating.
Fig. 8
12
1
2