Vacuuming Films - Silvercrest SFS 150 A2 Instrucciones De Uso

Warning:
If the control lamp does not go out after 10
i
seconds at the latest, the appliance is defective!
Immediately remove the plug from the wall socket.
Do not attempt to repair the appliance yourself. In
this case, contact Customer Services.
³
Open the appliance cover
the film. This is sealed at one end and, at the
same time, separated from the roll of tube film.
Seal the remaining open sides, except for one,
in the same manner.
³
Fill the bag. You must leave at least 6 cm of the
bag free, measured up to the edge that is to be
sealed.
Warning:
Fill the bags in such a way that, under no circum-
stances, food remnants or fluids can run out of the
bag when sealing it and permeate into the appliance.
³
If you do not want to extract the air from the
bag, you should now seal the last open side.

Vacuuming films

When sealing, you can at the same time extract the
air from the bag (vacuuming):
Warning:
Do NOT vacuum bags in which there are liquids.
They will permeate into the appliance and damage
it.
u again and remove
- 35 -
³
Place the open end of the bag around the
extraction supports
them lightly. Thereby, the bag must project to
the markings in the appliance.
Note:
The bag opening must sit smoothly on the extraction
supports , the sealing wire
w
e . Otherwise, the vacuuming, sealing and cutting
will not function properly.
³
Close the appliance cover
it down on both sides. Be sure n n o o t t to press on
the Seal/Cut button
the bag.
. For this you can lift
w
and the cutting wire
r
u and firmly press
. Air is now sucked from
y