About This Document - Franklin Electric SubStart3P Manual De Instrucciones

About this document

• The instructions and information in this manual
form an integral part of the equipment and
describe its safe and intended use.
• Keep this manual in the immediate vicinity of the
installation.
• Hand this manual to any subsequent owner or
installer.
• The instructions and specifi cations only apply to
the equipment described in this manual.
• Technical changes may be made without notice
in the interest of product development.
Warnings notices and symbols
Warning notices
and symbols
DANGER!
WARNING!
INFORMATION!
Safety
Observe the safety rules in this manual.
Safety measures are listed in this section.
Intended use
• The equipment described in this manual is inten-
ded for use with a Franklin Electric submersible
motor.
• A correctly sized pump must be fi tted to the
motor.
• The pump and motor must operate under water
only.
• The pumping system must fulfi ll the applicable
directives, regulations and statutory provisions.
GB
Meaning
Direct/Immediate dan-
ger to life and/or health
Possible danger to life
and/or health.
Important information.
You should observe this
information to ensure
correct and safe ope-
ration. Possible danger
of physical harm and/
or material damage may
otherwise result.
Loss of guarantee and liability exclusion:
Franklin Electric shall not be liable for the damage
resulting from any non-intended use. The risk of such
use rests solely with the user.
Target group
Any electrical system such as described in this
manual must only be installed by professional staff
(qualifi ed electrical technician).
General safety instructions
The following safety instructions must be obser-
ved prior to putting the control gear into use:
• Mount the control gear in an appropriate loca-
tion, orientation and position.
• Do not modify the control gear or its electrical or
mechanical connections.
• Do not remove any part or parts of the control
gear.
• Never install any control gear with a known
defective motor.
• Remove power before working on control gear.
Switching off the power is not suffi cient.
• Make sure that nobody can switch on the power
unexpectedly while work is being carried out.
• Never work on electrical systems during a
thunderstorm.
• Commissioning or testing can only be performed
by qualifi ed professional staff (qualifi ed electrical
technician).
• Replace all protection and safety devices after
completing work.
• Ensure that all electrical connections and safety
devices have been checked and that all fuses
and safety devices have been set correctly
before switching on.
• Make sure that no danger zones are accessible
(e.g. electrical connections).
• Read the pump manufacturer's commissioning
instructions before switching on any control
gear.
• Repairs must only be carried out by authorized
professional workshops. Use only original
Franklin Electric spare parts.
1