Publicidad
Idiomas disponibles
Idiomas disponibles
Brief description
Suction connector
Adjusting screw for
belt
On-/off switch
Locking button
Electronic thumb wheel (only applicable for BBSE 1100)
Integrated dust removal
Changing the
belt
Setting speed of
rotation
(only applicable
for
BBSE 1100
ENGLISH
Always disconnect the plug from the
socket before carrying out any work on the
machine.
Prior the changing belt, adjust sanding belt
by turning the belt adjusting screw approx.
2–3 cm in the direction of the open side of
the machine beyond the rollers, whilst the
machine is running, as the new sanding
belt can sometimes brush against the
machine housing.
1.
Pull the clamping lever forwards
2.
Remove the worn belt and fit the inside of
the belt is pointing in the same direction as
the arrow on the machine.
3.
Push the clamping lever back again
4.
Taking a test run, position the sanding belt
with the aid of the belt adjusting screw so
that it is flush with the outer edge of the
sanding belt support.
The speed is adjusted by means of the
electronic thumb wheel.
1 = lowest speed
6 = highest speed
2
Modifications: Text, diagrams and data are correct
at the time of printing. In the interest of continuous
improvement of our products, technical
specifications are subject to alteration without prior
notice.
BBS 1100, BBSE 1100
Dust bag
Publicidad
