Initial Operation - Metabo HJA 14.4-18 Manual De Instrucciones

en ENGLISH
connection plug causes a malfunction of the
garment and increases the risk of electric shock or
fire.
The garment is water-repellent, in case the jacket is
wet it must not be used. Remove the battery pack
and the Power Adapter.
Do not fold a heated garment and do not store any
objects on top of it. A damaged heating element or
a damaged cable of the connection plug causes a
malfunction of the garment and increases the risk of
electric shock or fire.
Pay careful attention to the instructions for care and
cleaning of the garment. Lack of due diligence
carries the risk of electric shock or fire.
Leave the garment to cool completely before storing
it.
Check at regular intervals if the garment shows any
signs of wear or damage. If there are such signs or
if the garment has been used for other purposes, do
not continue to use the garment and return it to the
dealer.
Have your device serviced by a qualified repair
person using only genuine replacement parts. This
will ensure that the garment functions safely.
5. Overview
See Page 2 and 3.
1 Chest pocket with cable exit
2 Side pocket
3 Back pocket left
4 Connection plug left
5 Power Adapter (PA 14.4-18 USB LED) *
6 On/off switch heating zones hands / pockets
7 On/off switch heating zones body
8 Cable guide
9 Cable exit
* not in scope of delivery

6. Initial Operation

Connect the heated jacket with the cable provided
(4) to the Power Adapter (5). Ensure that the plug is
inserted completely.
See image A, page 3:
Connect the connection plug of the left back pocket
(4) to the 12V connection of the Power Adapter (5)
(observe operating instructions of the
Power Adapter!).
Subsequently switch on the Power Adapter.
(observe operating instructions of the
Power Adapter!).
The Power Adapter can be stored in the back
pocket (3) provided.
Close the zipper completely.
Alternatively, the cable can be guided with the
connection plug (4) through the cable outlet (9)
through the inside of the jacket and the Power
Adapter can be fixed (5) at the belt.
10
When using USB devices use the provided pockets,
cable guides (8) and openings (9).
7. Use
7.1 Heating zones
In total, the jacket has 6 heating zones.
2 heating zones for the hands / pockets on the front
side:
4 heating zones for the body (front side and back
side):
7.2 Switching on/off of the heating elements
Switching on: Press the on/off switch (6)/ (7) of the
desired heating zone (about 2 seconds) until the
push button flashes.
Note: After switching on, the flashing heat pulse
mode is always set. If no changes are effected to
the heating stages, the heating power is reduced
automatically to the high heating stage after about 5
minutes.
Switching off: Press the on/off switch (6)/ (7) of the
respective heating zone until the push button is no
longer lit.
7.3 Set heating stages
The heating stage is indicated by the colour of the
push button's illumination. Each time the button is
pressed, the colour changes (heating stage), press
the on/off switch (6)/ (7)until you have set the
desired heating stage. The heating stage can also
be set manually when the button is flashing.
Light colour
flashing red
red
orange
blue
Heating output
high (fast heat
pulse)
high
medium
low