Technical Data; Limited Warranty - GreenWorks Pro 2004502AZ Manual Del Operador

EN
Problem
The motor runs
and the chain ro-
tates, but the chain
does not cut.
The machine does
not start.
The motor runs,
but the chain does
not cut correctly,
or the motor stops
after around 3 sec-
onds.
Possible cause Solution
Sharpen or replace
The chain is blunt.
the saw chain.
Turn the chain
The chain is in the
loop to the other
incorrect direction.
direction.
The chain is tight Adjust the chain
or loose. tension.
Pull the chain
The chain brake is brake in the direc-
engaged. tion of the user to
disengage it.
Make sure that the
The machine and
battery release
battery are not
button clicks when
connected correct-
you install the bat-
ly.
tery pack.
The battery level Charge the battery
is low. pack.
1. Push the lock-
out button and
The lock out but-
hold it.
ton and the trigger
are not pushed at
2. Push the trig-
the same time.
ger to start the
machine.
Refer to battery
The battery is too
and charger man-
hot or too cold.
ual.
Release the trigger
The machine is in
and start the ma-
the protection
chine again. Do
mode to protect
not force the ma-
the PCB.
chine to cut.
Charge the battery.
Refer to the bat-
The battery is not tery and charger
charged. manual for correct
charging proce-
dures.
Lubricate the
chain to decrease
the friction. Do
The chain is not
not let the guide
lubricated.
bar and the chain
operate without
sufficient oil.
Cool the battery
Incorrect battery
pack until it de-
storage tempera-
creases to the am-
ture
bient temperature.
English
14

TECHNICAL DATA

Voltage
No load speed
Guide bar length
Chain pitch
Chain gauge
Drive links
Chain oil capacity
Weight (without battery
pack)
Chain
Guide bar
Battery model
Charger model
15

LIMITED WARRANTY

Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of four (4)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been hired or rented for industrial/commercial use, and that
have been maintained in accordance with the instructions in
the owners' manual supplied with the product from new.
ITEMS NOT COVERED BY WARRANTY:
1. Any part that has become inoperative due to misuse,
commercial use, abuse, neglect, accident, improper
maintenance, or alteration; or
2. The unit, if it has not been operated and/or maintained in
accordance with the owner's manual; or
3. Normal wear, except as noted below;
4. Routine maintenance items such as lubricants, blade
sharpening;
5. Normal deterioration of the exterior finish due to use or
exposure.
14
80 V DC
10.5 m/s
16'' (400 mm)
3/8" LP (9.5 mm)
.050" (1.27 mm)
56
180 ml
9.5 lbs (4.3 kg)
91PJ056X
160SDEA041
2901302 and other BAB
series
2901402 and other CAB
series