Checking, Maintaining And Servicing The Machine's Safety Equipment - Youngman Richardson & Co DM 230 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Ground fault circuit interrupter
Ground fault circuit interrupters are for protection in case an
electrical fault should occur.
The LED indicates that the ground fault circuit interrupter is on
and that the machine can be switched on. If the LED is not
on, push the RESET button (green).
Checking, maintaining and servicing
the machine' ' ' ' s safety equipment
IMPORTANT! All servicing and repair work on the machine
requires special training. This is especially true of the
machine's safety equipment. If your machine fails any of the
checks described below you must contact your service
agent. When you buy any of our products we guarantee the
availability of professional repairs and service. If the retailer
who sells your machine is not a servicing dealer, ask him for
the address of your nearest service agent.
Checking the power switch
Start the machine, release the power switch and check that
the motor and the drill bit stop.
A defective power switch should be replaced by an authorized
service workshop.
Checking the power switch lock
Press the power switch and check that the power switch is
locked when the power switch lock is pressed in.
Press in the power switch and make sure the switch returns
to its original position when you release it.
Check that the power switch and the power switch lock move
easily.
SAFETY INSTRUCTIONS
Check the ground fault circuit interrupter
Connect the machine to the socket. Push the RESET button
(green) and the red LED lights up.
Push the TEST button (blue).
The ground fault circuit interrupter should trip and the
machine switch off instantly. If not, contact your dealer.
Reset with the RESET button (green).
– 9
English

Publicidad

Tabla de contenido
loading

Tabla de contenido