Installation; Preparations - Funkwerk MULTI MODE COMPENSER UMTS/GSM-MMC Instrucciones De Montaje

GB Installation

Installation

Improper installation
Improper installation can cause damage to the device or vehicle!
Specific knowledge and skills are required to install the COMPEN-
SER.
We strongly recommend that the installation is carried out in a spe-
cialist workshop.
The COMPENSER should preferably be installed in the vehicle's boot, as close as
possible to the mobile phone antenna. Installation within the engine compart-
ment is not permitted.
The UMTS/GSM MMC must not be opened. Interference will render the guaran-
tee invalid.
For servicing purposes, please contact your specialist dealer or our service
department (see "Hotline" chapter).

Preparations

First of all, determine where the COMPENSER is to be installed. In doing so, you
should consider the safety criteria and remember that it should be installed as
close to the antenna as possible.
Now determine the connection points for constant positive (terminal 30, +), earth
(terminal 31, -) and ignition/positive connected (terminal 15, Ign.). The connec-
tion points for constant positive and ignition must be fused. The following fuse
ratings may be used:
Constant positive:
Ignition:
For optimum operation, the antenna cable should be kept as short as possible.
If your vehicle antenna already has a cable, this can be shortened if required. The
necessary FME cable plugs and crimping tools are available from specialist dea-
lers.
The HF cable included in the scope of supply has an FME connector as most
antennas have an FME connection.
For antennas without an FME connection, please ask your dealer about adapter
options.
If possible, do not use mobile phone antennas with very thin HF cable (e.g. RG
174), as this will result in increased transmission losses, particularly with GSM
1800 and UMTS.
5A fuse
5A fuse
-18-
UMTS/GSM-MMC