Installing The Burette Tip - Xylem SI Analytics TITRONIC 500 Manual De Instrucciones

2.8

Installing the burette tip

The burette tip consists of the elements shaft with threaded clamping joint, hose and slip-on tip (Fig. 24).
tip
Fig. 24
Burette tip - Sequence of assembly:
1. Cut of hose end evenly.
2. Slip parts of the threaded clamping joint on to the hose.
3. Guide hose through shaft.
4. Press the free hose end over the ring marking until it reaches the stop of the tip.
5. Push the tip with pressed in hose onto the shaft.
6. Hold tip firmly, and screw threaded clamping joint to the shaft
stop
ring marking
hose
shaft
threaded clamping joint
tip
101