LEMAN LOPON150 Manual De Instrucciones página 21

- Mark holes on workbench where the machine is to be mounted, using holes in the base as a template for hole
pattern.
- Drill holes through workbench and place the machine on workbench by aligning holes in the base with holes
drilled in the workbench.
- Insert bolts (not supplied) and tighten securely with lock washers and hex nuts (not supplied).
6.2 Installing the sanding disc and the disc guard (Fig 1)
- Remove the backing from the sanding disc.
- Align the perimeter of the sanding disc (4) with the plate and press firmly into position.
Make sure the sanding disc is stuck properly and in a flat position.
- Place the disc guard (11) and align holes.
- Use the two Phillips screws ST4.2x10 (12) to securely tighten the disc guard in place.
6.3 Installing and adjusting the work table for sanding disc (Fig 2 & 3)
The worktable (6) can be tilted from 0° to 45° for bevel sanding.
- Insert the work table index pin into the hole of the tool's housing.
- Position the flat washer over the table lock knob (8) then tighten the table lock knob (8) securely.
To tilt the worktable:
- Loosen the table lock knob (8) by turning it counterclockwise.
- Set the worktable (6) to desired angle by using the bevel scale.
- Tighten the table lock knob (8) by turning it clockwise.
6.4 Installing the sanding belt limiting plate (Fig 4)
Use the limiting plate (1) for horizontal sanding with the belt.
- Place the limiting plate (1) on the side of the sanding belt support.
- Fasten the limiting plate with two hex cylinder screws M8x16 (13) and flat washers, by using the hex key.
6.5 Installing and adjusting the work table for sanding belt (Fig 5 & 6)
The worktable (6) can be installed on the sanding belt support for vertical sanding with the belt.
- Insert the work table index pin into the hole on the side of the sanding belt support.
- Position the flat washer over the table lock knob (8) then tighten the table lock knob (8) securely.
To tilt the sanding belt support:
- Loosen the hex socket screw M8x25 (14) by using the hex key.
- Move the sanding belt support into the vertical position, then lock it by retightening hex socket screw (14).
6.6 Installing the miter gauge (Fig 7)
The miter gauge (7) is recommended for sanding small end surfaces on the sanding disc.
- Insert the miter gauge sliding bar into the worktable groove.
6.7 Dust extraction (Fig 7)
CAUTION:
- Dusts from materials such as lead-containing coatings, some wood types, can be harmful to one's health.
Touching or breathing-in the dusts can cause allergic reactions and/or lead to respiratory infections of the user or
bystanders.
- Certain dusts, such as oak or beech dust, are considered as carcinogenic, especially in connection with wood-
treatment additives (chromate, wood preservative).
- Materials containing asbestos may only be worked by specialists.
- Prevent dust accumulation at the workplace; dusts can easily ignite.
- Provide for good ventilation of the working place.
- It is recommended to wear a P2 filter-class respirator.
- Observe the relevant regulations in your country for the materials to be worked.
The dust ejector (9) is on the left side of the machine.
- Connect the vacuum cleaner to the dust ejector (9) with an extraction hose (not supplied).
The vacuum cleaner must be suitable for the material being worked.
GB
21