Sharpening Of Blades; Adjusting Blades And Counter Blades - TRAPP ES-500 Manual De Instrucciones

www.trapp.com.br

Sharpening of blades

To keep cutting quality and to obtain the best
performance of your animal ration shredder, keep
blades in good working conditions. Periodically
check the status of the blades, sharpening them
whenever necessary.
With the machine off:
1. Open the cover.
2. Disassemble all rotor blades, removing securing
screws (A).
3. Sharpen each blade, trying to keep the original
cutting inclination. Whenever sharpening, be
careful to always remove the same amount of
material from each blade not to impair rotor
balance which may cause vibration.
4. Reassemble blades on rotor.
A
!
Danger!
Before assembling the blades, fix
them with the respective screws. After
assembly, carefully check whether all
screws are properly tight.
Maintenance Instructions
Important:
After blades are sharpened, it is necessary to
adjust blades/counter blades, as described
below.

Adjusting blades and counter blades

The blades shall be as close as possible to
the counter blades, without touching them.
The recommended distance between them
is approximately 1.5 mm.
With the machine off:
1. Loosen the blade support securing
screws (B).
2. Displace the support with the blade
so that you have 1.5 mm between the
blade and the counter blade.
3. Retighten all blade support screws.
4. Repeat the operation with each blade.
B
49