Peg-Perego Venezia Instrucciones De Uso página 12

B: A lowered position, obtained by
pressing the basket down, to allow
you to use it even when the backrest is
completely lowered.
C: Basket raised to allow access to the
rear footrest.
BRAKE
8• The stroller has brakes on all four wheels,
since the handlebar is reversible. It is
necessary to brake only the wheels that
are on the same side of the stroller as the
handlebar. To brake the stroller, push the
brake levers on the wheels downwards
with your foot, as shown in the figure.
Always set the brake when the stroller is
not moving.
SAFETY BELT
9• A: Make sure that the brace is properly
inserted by pushing as shown in the
figure. B: Fasten the belt as shown in the
figure.
10• To unfasten the belt, press on the buckle
sides and pull out the waist strap.
11• The new safety belt is now easier to
fasten thanks to the "snap-open-and-
shut" device. Before fastening the safety
belt, attach the buckle to the backrest
by inserting the tab through the special
holder, as shown in the figure. After
fastening the safety belt on your child,
detach it from the backrest to allow the
child more freedom of movement. The
buckle must remain below the child's
shoulders.
ADJUSTING THE BACKREST
12• The backrest reclines to three different
positions. To lower the backrest, lift the
handlebar and fix the backrest in the
desired position. To raise the backrest,
pull it upwards.
ADJUSTING THE FOOTREST
13• The footrest can be adjusted to two
positions. To lower it, pull the two levers
downwards while lowering the footrest,
as shown in the figure. To raise the
footrest, lift it upwards until it clicks into
place.
SWIVELING WHEELS
14• Since the stroller handlebar is reversible,
all four of the stroller wheels can be set
to swivel. It is necessary to swivel only
the wheels that are on the opposite side
of the stroller from the handlebar. Lift the
lever as shown in the figure to allow the
wheels to swivel. Lower the lever for fixed
wheels.
FRONT BAR
15• The front bar can be extended to two
positions. To extend it to the first
position, pull the two little levers under
the front bar and the front bar towards
you, until you hear the first click. To
extend the front bar to the second
position, pull the two levers and the front
bar towards you again until you hear the
second click.
16• When your children are bigger, you can
remove the front bar. To detach the bar,
press the buttons under the armrests,
while pulling the front bar out.
"CHILD TRAY"
17• To hook the child tray to the stroller,
extend the front bar to the second
position and then hook the tray onto it by
pushing it down as shown in the figure.
18• To remove the tray, push out the two
side tabs of the tray as you lift the tray
upward. It is dangerous to put hot drinks
on the tray.
HANDLEBAR
19• To reverse the handlebar, simultaneously
pull the little levers on the handlebar
upwards and move the handlebar to the
opposite position, pressing until you hear
the final click. While carrying out this
operation, be very careful not to catch
your child's hands or arms.
20• To adjust the handlebar height, press the
side buttons simultaneously, as shown
in the figure, and lock the handlebar into
the desired position.
DRINK-HOLDER
21• The drink-holder attaches to both the
right and the left-hand sides of the
handlebar. To attach the drink-holder,
slip the attachment onto the handlebar,
and push downwards until it clicks into
place. Do not place hot drinks in the
drink-holder. Do not place anything
heavier than 1 Kg. (2.2 lbs.) in the drink-
holder.
BABY CARRIAGE AND/OR STROLLER
22• A) BABY CARRIAGE: Venezia becomes
a baby carriage when the backrest is
lowered to the last position, with the
footrest raised, the handlebar positioned
opposite the backrest, and the wheels
on the same side as the backrest set to
swivel.
• B) STROLLER: Venezia becomes a
stroller when the backrest is raised,
with the footrest lowered, the handlebar
positioned on the same side as the
backrest, and the wheels opposite the
backrest set to swivel.
HOOD
23• To attach the hood, insert the tabs
into the special notches on the stroller
armrests as shown in the figure, and
fasten the hood to the back of the
backrest.