Cutting Width; Operate The Machine; Maintenance; Clean The Machine - GreenWorks CRD401 Manual Del Operador

EN
10.5

CUTTING WIDTH

1. Loosen the width adjustment knob to move the edge
guide to the necessary width.
2. Tighten the width adjustment knob after adjustment.
10.6

OPERATE THE MACHINE

Kickback occurs when the blade stalls quickly and the
machine is driven back to you. A step which pinches the
blade in the wood can cuase blade stalling.
English
@ 90°
@ 0°
10
WARNING
To prevent kickback, release switch trigger immediately if
the blade stalls.
1. Keep the blade at the correct depth position.
2. Examine the workpiece for nails before you cut. Do not
saw into a nail.
3. Make straight cuts. Use a straight edge guide when rip
cutting. This helps prevent you twist the blade.
4. Use clean, sharp, and correctly set blades. Do not make
cuts with blunt blades.
5. Support the workpiece correctly before you begin a cut.
6. Use stable pressure when you make a cut. Do not force a
cut.
7. Do not cut warped or wet lumber.
8. Hold the saw tightly with the two hands and keep your
body in a balanced position to against the forces if
kickback occurs.
11

MAINTENANCE

CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
11.1

CLEAN THE MACHINE

CAUTION
The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with a
vacuum cleaner.
• Do not spray the air vent or put the air vent in solvents.
• Clean the housing and the plastic components with a
moist and soft cloth.
12

TECHNICAL DATA

Voltage
Motor
No Load Speed
24 V
Brushless
4,500 RPM