Beper 90.385 Manual De Instrucciones página 9

Electric Barbecue Use instructions
Warning! Do not use the plate if empty, always fill the tray with water.
While being used, the appliance heats up a lot. Set the appliance in a safe place before
using it and do not touch the metal grill or the resistance once the appliance is on.
The appliance can be put away only when it is completely cold.
Use the appliance only with food free of packaging or wrapping materials, as they may
cause fire hazard.
Never use the appliance when off to lay food or pots on it. If the appliance is accidentally
turned off, this may cause damage or accidents.
Do not use coal or any fuel in general.
Be careful when you use seasoning oil as it can cause boiling steam.
COMPONENTS
1. Windshield
2. Grid plate
3. Grill
4. Heating element
5. Drip tray
6. Rack
7. Steel tube(up)
8. Plastic board
9. Steel tube(down)
10. Foot
OPERATION
Place the electric grill on a flat and even surface, out of the reach of children. Keep at least 10cm
between the appliance and any object around it. While the appliance is on, or immediately after it
is turned off, the grill, the plate and the water in the tray are hot. Wait for these elements to cool off
to move the appliance. Do not touch the grill. Handle it using the hook supplied with the appliance.
Add water to the tray but never exceed the "MAX" mark on the level indicator.
Connect the appliance to 220-240V 50Hz electric current.
Turn the temperature control knob to the "1-2" position.
Light turns on and resistance starts to warm up.
Turn knob clockwise to select the power desired.
(1 = minimum power; 5 = maximum power)
Wait 5 – 10 minutes for the plate to heat up.
Select the plate position, high or low, at will
Place food evenly on grill.
To switch off the grill, turn knob to "0", and the ON/OFF light comes off.
Disconnect the plug from the mains and allow the appliance to cool off for some minutes to put it
away.
9