GB
INSTALLATION INSTRUCTIONS
for LA Type Shower Trays
1.
Draw the basic axis on the under side of the shower tray according to the type of the tray.
2.
Place the bearer
spacing between the axis and the inner edge of the bearer and draw the outline of the bearer on
the tray bottom.
3.
Adjust the bearer so that it does not impede the frontal encasing. On the reinforced shower tray
base, mark out four positions for the mounting holes. Follow the same steps to measure and
mark out the position of the other bearer mounting holes.
4.
In the marked positions now drill four
into the reinforced part only, 10 mm deep, in order to not damage the shower tray bottom.
5.
(5)
Using the bolts
(4)
with nuts
and plastic legs
6.
Set the shower tray into its intended installation position. By twisting the plastic legs, level the
tray; using a spirit level to check. Tighten the setting nuts
7.
Draw the outline of the shower tray upper edge on the bathroom wall; mark out axes of the
mounting clips 100 mm from the tray corners. Set the tray aside.
8.
On these axes mark out and drill
edge. Insert wall plugs and attach the mounting clips from the shower tray mounting kit. Apply
some silicon putty into the upper rods of the clips and hang the shower tray on the clips.
9.
Following the basic instructions included in the shower tray package, install and connect the
waste siphon, and seal the shower tray to the bathroom walls.
MOUNTING KIT:
1. Bearer
2. Plastic leg M 12 x 40
3. Thread Rod M 12 x 85
4. Nut M 12
5. Self-tapping screw
6. Drill Bit
Ø
3 mm
SHOWER TRAY TYPE
RONDA 80
RONDA 90
RADIUS 90
ANGELA 80
ANGELA 90
PERSEUS 80
PERSEUS 90
PERSEUS 100
tel.: 318 427 111, 318 427 200, fax: 318 427 269, 318 427 278, e-mail: smith@ravak.cz. www.ravak.com
(1)
on the tray bottom so that it is parallel with the axis; measure out the " "
(1)
, screw the bearer
(2)
into the
Ø
8 mm openings exactly 50 mm under the shower tray upper
2 pcs
4
pcs
4
pcs
12
pcs
Ø
5,5 x 16
8
pcs
1
pc
L SPACING
BASE
600
650
650
600
650
600
650
750
RAVAK a.s., Obecnická 285, 261 01 Pøíbram 1, Czech republic
for the „UNIVERSAL BASE" Support
3 mm mounting holes for each bearer. ATTENTION! Drill
Ø
onto the shower tray bottom. Insert the threaded rods
Ø
12,5 mm openings.
(4)
For each type and size of the shower tray there is
different length of the bearers: 600 mm, 650 mm, or
750 mm.
SHOWER TRAY TYPE
140
ELIPSO 80
160
ELIPSO 90
160
ELIPSO 100
140
MODUS 90
160
ANETA 75x90
140
PENTA 90
160
GENTA 90
210
.
BASE
600
650
750
650
600
600
650
L
(3)
L SPACING
85
140
160
140
2L=280
160
140