After Use - Ibiza sound COMBO208-VHF Manual De Instrucciones

MONITOR OUTPUTS: You can connect these outputs to a variety of devices like a recorder, an active sub-woofer, another
power amplifier and speakers or another mixer.
a. Turn down the "MONITOR OUTPUT VOLUME" (7).
b. Connect the MONITOR OUTPUTS (RCA) to the inputs of the device into which you want to plug the mixer.
c. Set the input level of the external device according to the manufacturer instructions.
d. Increase the "MONITOR OUTPUT VOLUME" gradually until you have reached the desired volume.
Functions
1. MP3 Player
MODE Exchange between USB / SD / BLUETOOTH
BLUETOOTH
Play/Pause
Repeat
Last
Next
2. Volume: Master volume control. When the POWER light is on, the speaker is working. When the LIMIT light is on, the
speaker power exceeds the limited level to distortion.
3. Reverb function of the wireless mic
4. Volume : MP3 volume control
5. Volume : to control the stereo input for 3/4 and 5/6 channel
6. Stereo input of Channel 3/4
7. Volume : to control the monitor output
8. Monitor output
9. Stereo input of Channel 5/6
10. TREBLE: to control the high frequencies (CH1)
11. Bass : to control the low frequencies (CH1)
12. Reverb function of Channel 1
13. ON/OFF switch to control the reverb function of Channel 1
14. Volume : to control Channel 1
15. Line input of Channel 1
16. Wired mic input of Channel 1
17. TREBLE: to control the high frequencies (CH2)
18. Bass : to control the low frequencies (CH2)
19. Reverb function of Channel 2
20. ON/OFF switch to control the reverb function of Channel 2
21. Volume : to control Channel 2
22. Line input of Channel 2
23. Wired mic input of Channel 2
24. ON/OFF switch of the VHF function
25. Antenna for wireless mic A
26. Light indicator for wireless mic A / Volume control for wireless mic A
27. Light indicator for wireless mic B / Volume control for wireless mic B
28. Antenna for wireless mic B

AFTER USE

Turn down the "MASTER VOLUME" control.
Turn the mixer off.
Disconnect the AC Power cable from the mixer and then unplug the cable from the mains outlet.
Disconnect the speaker cables from the mixer and then disconnect the speaker cables from the speakers.
Disconnect all other inputs (microphones, instruments or music players) from the mixer.
Store the cables in the storage compartment and fasten the latch.
To fasten the storage module or mixer module on the rear of the speakers simply reverse the process described in the
"Getting Started" chapter of the manual.
CAUTION:
Only use the system as a whole with all parts. Substituting different speakers could result in damage to the powered mixer
and could void your warranty. The powered mixer will not work with speakers whose impedance is lower than 8 ohms.
COMBO208-VHF
5