Descargar Imprimir esta página

Zibro Kamin R 419 C Instrucciones De Uso página 58

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 41
E
K
L
F
broken ignition coil
After having ignited the heater, always check whether the combustion
chamber ¿ is level, by sliding it slightly to the left and the right by its handle
(Fig. E) ´. This should be a smooth movement. If the combustion chamber is
not level, this will cause smoke and soot to develop.
D
THE BURNING OF THE HEATER
After you have ignited the heater, it will take 10 to 15 minutes before you can
check whether the heater is burning well. Too high a flame may cause smoke and
soot, whereas too low a flame causes smells. The page opposite the folding page
shows the minimum and maximum permissible burning heights of the flame (Fig. P).
The flame can be slightly adjusted with the flame regulator · (Fig. K).
Too low a flame may also be caused by:
insufficient fuel
poor fuel quality
insufficient ventilation
wastage of the wick
This heater is fitted with a safety system that ensures that it switches off if you
lift the exchange tank out of the heater for more than 5 seconds. To switch the
heater on again, put the exchange tank back and follow the steps in chapter C.
E
SWITCHING OFF THE HEATER
Let the heater burn at its lowest setting for approximately one minute. Then
slowly slide up the flame regulator · (Fig. K). The flame will extinguish by itself.
In cases of emergency: switch off the heater with the safety device ³ (Fig. L).
F
MALFUNCTION, CAUSES AND SOLUTIONS
If any malfunctioning cannot be solved from the directions below, please contact
your Zibro Kamin dealer.
THE HEATER DOES NOT IGNITE
The batteries are not positioned correctly in the holder. Check (Fig. F).
There is not enough power left in the batteries for the ignition. Replace (Fig. F).
You have run out of fuel from the tank or the wick has been replaced.
After having refilled and replaced the removable tank, wait for 30 minutes
before igniting the heater.
You are pushing down the igniter slide » with too much force.
Push it down less forcefully (Section C).
The ignition coil ¸ is defective.
Contact your dealer.
(fill the tank)
(contact your dealer)
(leave window or door ajar)
(contact your dealer or replace the wick,
refer to section L)
4
55

Publicidad

loading