Assembly - Textron GREENLEE UT2 Manual De Instrucciones

Assembly

Insert the foot with the wheels into the leg and attach it
with the two detent pins as shown in Fig. 1 such that the
central holes of the foot aligns with the outboard holes
of the leg.
Mount the puller to the leg assembly by sliding the
hole in the leg over the 1" shaft opposite the capstan
as shown in Figure 2. Retain it with the 1/4" screw and
washer (or hitch clip if so equipped).
Greenlee / A Textron Company
Fig. 1
Fig. 2
UT2 Cable Pulling System
Slide the boom tube onto the puller and attach with
the detent pin as shown in Fig. 3. Note that the small
sheave should be on the same side as the capstan.
Finally, slide the nose unit into the boom tube and attach it
with a detent pin at the desired length as shown in Fig. 4.
7
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Fig. 3
Fig. 4