MCS Master BV 471S Manual De Instrucciones página 13

IMPORTANT: READ AND UNDERSTAND THIS OPERATIONAL MANUAL PRIOR TO
en
ASSEMBLING, STARTING UP OR CONDUCTING MAINTENANCE ON THIS HEATER.
it
USING THE HEATER INCORRECTLY CAN CAUSE SERIOUS OR FATAL INJURIES. KEEP
de
es
fr
►►►1. DESCRIPTION
This series of heaters is particularly suited to heating
nl
medium to large-sized rooms or areas.
Thanks to an internal heat exchanger, indirect heaters
pt
(PIC. 1) separate combustion gases from the hot air
released into the environment. This way it is possible
da
to have a flow of clean hot air in the area that needs to
be heated up and direct combustion products outside.
fi
These heaters have been designed in line with the
most recent safety, operating and duration criteria.
no
The safety devices ensure the heater always operates
correctly.
sv
pl
►►►2. SAFETY INFORMATION
WARNINGS
ru
IMPORTANT: This air heater has been
cs
designed for mobile and temporary professional
applications. It has not been designed for
hu
domestic use nor for thermal comfort of human.
sl
IMPORTANT: This appliance is not suitable
tr
for use by persons (including children) with
reduced physical, sensory or mental capacities
hr
or who lack experience or knowledge unless
supervised by a person responsible for their
lt
safety. Children must be supervised to make sure
they do not play with the appliance.
lv
DANGER: Suffocation by carbon monoxide
et
can be fatal.
ro
The first symptoms of suffocation by carbon
monoxide are similar to those of flu with headache,
sk
light-headedness and/or nausea. These symptoms
could be caused by the faulty functioning of
bg
the heater. IF THESE SYMPTOMS OCCUR, GO
OUTDOORS IMMEDIATELY and have the heater
uk
repaired by the technical support centre.
►►2.1. REFUELLING:
bs
►2.1.1. Personnel appointed to carry out refuelling
must be qualified and fully familiar with the
el
manufacturer's
regulations on how to refuel heaters safely.
zh
►2.1.2. Only use the type of fuel specified on the
heater's identification plate.
►2.1.3. Before refuelling, turn off the heater and
wait for it to cool down.
►2.1.4. The tanks used to store the fuel must be
stored in a separate place.
►2.1.5. Fuel tanks must be kept at a minimum
distance from the heater, in accordance with
current standards.
THIS MANUAL FOR FURTHER REFERENCE.
instructions and current
►2.1.6. The fuel must be stored in an area where
the floor does not allow it to penetrate or drip
onto flames underneath it, which may ignite the
fuel.
►2.1.7. The fuel must be stored in accordance with
current regulations.
►►2.2. SAFETY:
►2.2.1. Never use the heater in areas with petrol,
paint solvents or other highly flammable vapours.
►2.2.2. Comply with all local legislation and current
regulations when using the heater.
►2.2.3. Heaters used near tarpaulins, curtains or
other similar covering materials must be a safe
distance from them. It is advised to use fire-proof
covering material.
►2.2.4. Only use in well-ventilated areas. Set-up a
suitable opening in line with current standards,
with the purpose of introducing fresh air from
outdoors.
►2.2.5. Power on the heater only with a current
which has the voltage and frequency values
specified on the identification plate.
►2.2.6. Only use suitably earthed extension cables.
►2.2.7. Recommended safety distances between
the heater and flammable substances: front
output 2.5 m; on the side, at the top and at the
back = 1.5 m.
►2.2.8. Avoid fire hazards by placing the hot or
functioning heater on a steady level surface.
►2.2.9. Keep animals at a safe distance from the
heater.
►2.2.10. Disconnect the heater from the mains
power supply when not in use.
►2.2.11. When it is controlled by a thermostat, the
heater can turn on at any time.
►2.2.12. Never use the heater in frequently used
rooms nor in bedrooms.
►2.2.13. Never block the heater's air vent or the air
outlet.
►2.2.14. Never move, handle, refuel or conduct
maintenance on the heater when it is hot,
connected to the mains or in operation.
►2.2.15. Only use original kits to direct the air
coming in and/or going out (where applicable).
►2.2.16. Keep the hot parts of the heater at a suitable
distance from inflammable or thermolabile
materials (including the power supply cable).
►2.2.17. If the power supply cable is damaged, it
must be replaced by a technical support centre
to prevent any risk.
►2.2.18. During operation, make sure that the fire-
fighting devices are ready for use.
►2.2.19. Use original spare parts when replacing
the burner, strictly complying with indications
regarding capacity, type of nozzles and pump