Maintenance; Specifications - Aiwa CT-FX530M Manual De Instrucciones

MAINTENANCE

Cleaning the front panel
When the front panel is soiled, wipe the surface
of the panel with a soft, dry cloth.
Cleaning the tape head
Use a cleaning cassette to clean the playback
head and capstans approximately once a month.
If the head is dirty, the high tones may not be
reproduced properly.
Cleaning the connector
The connector on the reverse side of the front
panel needs to be cleaned occasionally. Wipe
the surface of the connector with a cotton swab
slightly moistened with alcohol.
19
ENGLISH

SPECIFICATIONS

RADIO SECTION
(FM)
Frequency Range: 87.5 MHz – 108 MHz
(100-kHz steps)*
87.5 MHz – 108 MHz
(50-kHz steps)*
Usable Sensitivity: 12.7 dBf
50 dB Quieting Sensitivity:
17.2 dBf
IF Rejection: 80 dB
Frequency Response: 30 Hz – 15,000 Hz
S/N Ratio: 63 dB
Stereo Separation: 35 dB at 1 kHz
Alternate Channel Selectivity:
70 dB
Capture Ratio: 3 dB
(AM)
Frequency Range: 530 kHz – 1,710 kHz
(10-kHz steps)*
531 kHz – 1,602 kHz
(9-kHz steps)*
Usable Sensitivity: 30 µV (30 dB)
* Set the frequency increment for your area using
the switch on the bottom of the unit.
(The switch is set at the factory to the 10k position [for the
U.S.A.])
TAPE SECTION
Tape Speed: 4.8 cm/sec. (1
S/N Ratio: 50 dB
Frequency Response: 40 Hz – 14,000 Hz
Stereo Separation: 40 dB
FF/REW Time: 100 sec. (C-60)
AUDIO SECTION
45 W × 4 channels
Max. Power Output:
AUX IN input
Input sensitivity (load impedance)
AUX IN: 300 mV (10 kΩ)
7
/ ips)
8
tousi-E-20