Telcoma PASSO CARD Instrucciones De Uso página 39

OPERATION AND SIGNALS
Pass the CARD over the reader to activate the devices.
If the LED (DET. 1 in fig. 1) goes out for a moment and/or a beep is heard,
the CARD is in the memory and the receiver has activated the associated
output.
A sequence of 4 beeps and LED flashes, after a CARD is read, indicate
that the code read is not in the memory, and the receiver will not activate
either output.
A sequence of 10 beeps and LED flashes, after a CARD is read, indicate
that the communication line to the receiver has failed.
The MASTER CARDS are only enabled for programming functions and
cannot be used to activate devices directly.
MODIFICATIONS OR REPLACEMENTS IN THE
SYSTEM
To replace a reader (in the event of a failure) or add another to the
receiver, proceed as follows:
- Make the connections as described in the installation section.
- Memorise the MASTER CARD
The USER codes will not be lost because they are retained in the receiver
part.
If the receiver part is replaced, to avoid losing all the codes saved, remove
the memory (det. 5 in fig. 3) from the old receiver and fit it in the new one.
GB
38