Cable Entry And Assembling; Common Technical Details; Safety Instructions - Eneo VHM-EC/ST Serie Instrucciones De Manejo E Instalación

Carcasa protectora contra el polvo y la intemperie
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

I Technical details
I.1 Types
Type
Description
VHM/EC
Weatherproof housing
VHM/ST
Weatherproof housing
VHM/DP-EC
Dustproof housing
VHM/DP-ST
Dustproof housing
I.2 Cable entry and assembling
Economy (EC):
3 glands (M6x.5)
Standard (ST):
same as for EC, but with inside
central plug connection
I.3 Common technical details
Max. input voltage
Max. input current
Screen heater
Temperature range
Noise generation
Protection class
The VHM housing series is designed mainly for cameras
with fixed focus and most /3" - /" zoom lenses.
4-stage height adjustment of the camera for mounting
is possible using the rack-support (camera tray).
The accessories listed in section VI are for assembly
completion and making installation easier.
Execution
Economy
Standard
Economy
Standard
50V / 50Hz
300mA / AC
0-50V, 7W
-30V, 7W
-30° to + 60°C
(with screen heater)
< 70dBa
IP66

Safety instructions

The following instructions are for your own safety
and should be observed without fail:
• Please read the safety notes and following
installation instructions before connecting the unit.
• Keep the operating manual in a safe place for later
reference.
• The unit is only intended for permanent connection
to the power supply circuit.
• Only connect the device to a suitable electrical
source.
• Never operate the housing beyond its technical
specification.
• Pay attention to safety when laying the connection
cable and lay cable so that it cannot be buckled,
damaged, or subjected to loads or damp.
• If moisture has penetrated the device, do not switch
on under any circumstances.
In this case, have the device checked by a qualified
service technician.
• An easily accessible all-pole disconnecting
device with 3mm minimum contact gap width
is to be installed near the unit so that it can be
disconnected for service work. Earthing must be
low-resistance in compliance with DIN VDE 0100.
• The housing may only be opened by authorized
personnel. Connection work must be carried out
by a qualified technician.
• The warranty becomes void if repairs are undertaken
by unauthorized persons.
• Before opening the device, the mains voltage must
be switched off.
• Only DIN VDE 0860 and DIN VDE 0805 tested
components/tools are to be used for installation.
Installation is to be carried out in compliance with
the installation instructions and under observation
of all applicable standard regulations.
• Operate the device only at a temperature range of
-30°C to +60°C and at a humidity of max. 90%.
• The device must be protected from extreme heat,
dust, moisture and vibration.
• Do not place any heavy items on the device.
• The installer is responsible for maintaining the IP 66
protection system.
• Stainless screws must be used when installing the
unit outdoors.
• Only use original replacement parts from
Videor E. Hartig GmbH.


Publicidad

Tabla de contenido
loading

Tabla de contenido