Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
II Opening the housing
To open the housing, undo the two screws (a) (see fig. )
located in the middle section. The housing body can now
be pulled off the middle section. The plug on the heater
cable on models with built-in screen heater will have to
be disconnected either at the screw terminal board or
the power supply unit, depending on model. An adapter
(yoke) provides a removable connection with the camera
tray. To obtain free access to installed components,
slide housing body to end of range. In a vertical position
(c), it can now be folded down and moved to the rear.
Alternatively, it can be removed from the remaining
housing completely (see fig. ) by pressing both yoke
arms together in a horizontal position (d).
Fig.
The rear housing cover is fastened to the middle section
by 3 Allen screws (M4) with seal (see fig. ).
The housing's lower support rail serves as guide.
Fig.
a
Housing back view
yoke
Fold-down-mechanism / housing disassembling
(c)
3
b
Handle
b
(d)
a
b
Publicidad
Tabla de contenido
