When The Work Is Done - Siemens Z 4.0 Instrucciones De Uso

When the work is done

18
Figure
Unplug the vacuum cleaner.
Tug the power cord briefly and let go. The cable then
rewinds automatically.
19
Figure
To store/ transport the vacuum cleaner, use the
storage aid on the underside of the vacuum cleaner.
Stand the vacuum cleaner up on its end. Slide the
catch on the floor tool into the groove on the
underside of the appliance.
Changing the dust bag and filters
Replacing the dust bag
20*
Figure
a)If the dust bag change indicator is completely yellow
when the floor tool is lifted from the floor and the
highest suction power is selected, the dust bag must
be changed, even if it is not yet full. In this case it is
essential to change the dust bag due to the type of
material it contains.
First check that the nozzle, suction pipe and flexible
hose are not blocked, as this would also lead to the
dust bag change indicator being triggered.
b)The handle can easily be detached from the hose to
remove blockages.
21
Figure Opening the lid
Press the control button down to the stop and leave
it retracted in the appliance.
!
Caution: Only open the lid with the control button
retracted.
Open the lid by moving the locking lever in the
direction of the arrow.
22
Figure
a)Seal the dust bag by pulling the sealing strip and
remove the bag. .
b)Slide the new dust bag into the holder to the stop.
!
Caution: the lid will only close if a dust bag has been
inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly
by knocking out the dirt or rinsing it out.
23
Figure
Open the dust bag compartment lid
(see Figure 21).
Pull out the motor protection filter in the direction of
the arrow.
Clean the motor protection filter by tapping it.
If it is very dirty, the motor protection filter should
be rinsed out.
The filter must then be left to dry for at least 24
hours.
After cleaning, slide the motor protection filter into
the vacuum cleaner and close the dust bag
compartment lid.
Replacing the micro-hygiene filter
This should be replaced with every replacement filter
pack
24
Figure
Open the dust bag compartment lid
(see Figure 21).
Release the filter holder by moving the locking lever
in the direction of the arrow.
Remove the micro-hygiene filter. Insert the new
micro-hygiene filter into the vacuum cleaner.
Insert the filter holder into the vacuum cleaner and
clip into place.
Replacing the micro active carbon filter
If your vacuum cleaner is equipped with a micro active
carbon filter, this should be replaced every six months.
25
Figure
Open the dust bag compartment lid
(see Figure 21).
Release the filter holder by moving the locking lever
in the direction of the arrow.
Remove the micro active carbon filter.
Insert the new micro active carbon filter.
Insert the filter holder into the vacuum cleaner and
clip into place.
Replacing the HEPA filter
If your vacuum cleaner is equipped with a HEPA filter,
this should be replaced once a year.
26
Figure
Open the dust bag compartment lid (see Figure 21).
Release the Hepa filter by moving the locking lever in
the direction of the arrow and remove it from the
vacuum cleaner.
Insert the new HEPA filter and clip into place.
If you have used the vacuum cleaner for vacuuming fine
dust particles, clean the motor protection filter and, if
necessary, replace micro hygiene filter, the micro active
carbon filter or Hepa filter.
Care
Always switch off the vacuum cleaner and disconnect
the power cord from the mains before cleaning the
appliance. The vacuum cleaner and plastic accessories
can be cleaned with a commercial plastic cleaner.
!
Do not use a scourer, glass-cleaning agent or all-
purpose cleaning product. Never immerse the
vacuum cleaner in water.
The dust compartment can, if necessary, be cleaned
with a second vacuum cleaner or simply wiped with a
dry cloth or dusting brush.
Subject to technical modifications.
9