Installing The Shear Blades - Makita DUH551 Manual De Instrucciones

Installing the shear blades

Prepare 4 removed screws (For under cover), 2 screws
(For shear blade), plate, under cover, and new shear
blades.
Adjust the crank position as shown in the figure. At
this time, apply some grease provided with new shear
blades to the periphery of the crank.
1
► 1. Crank
Overlap the oval hole in the upper blade with that in the
lower one.
1
► 1. Oval hole of shear blade
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
Place the new shear blades on the tool so that the oval
holes in the shear blades fit onto the crank. Overlap the
holes in the shear blades with the screw holes in the
tool and then secure them with two screws.
2
► 1. Oval hole of shear blade 2. Crank 3. Screws
Check the crank for smooth turn with a slotted
screwdriver.
► 1. Crank
Install the plate, under cover on the tool. Tighten the
screw firmly.
NOTE:
• There is no distinction between the top and
bottom of the plate.
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
• When the shear blades does not operate prop-
erly, there is a poor fit between the blades and
crank. Redo from the beginning.
11 ENGLISH
1
1
3