Grinding The Shear Blades; Optional Accessories - Makita DUH501 Manual De Instrucciones

Storage
The hook hole in the tool bottom is convenient for hang-
ing t h e tool f rom a nail or s c re w on t h e w all.
Attach the blade cover to the shear blades so that the
blades are not exposed. Store the tool out of the reach
o f c h il d ren. S tore t h e tool in a pla c e not e x pose d to
moisture or rain.
Fig.33: 1. H ole

Grinding the shear blades

NOTICE:
If the shear blades have considerably
deformed by grinding, replace the shear blades
w ith ne w ones.
Install the battery cartridge to the tool.
1.
Turn on and start the tool so that the upper blade
2.
and lower blade are positioned alternately.
Fig.34
Turn off the tool and remove the battery cartridge
3.
f rom t h e tool.
Remove the screw, and then remove the branch
4.
c at c h er.
Fig.35: 1. S c re w 2. Bran c h c at c h er
Set the angle of a file to 4 , and grind the upper
5.
blade from directions with the file.
Fig.36: (1) F ile (2) 4 5 °
CAUTION:
Before grinding the shear blades,
make sure that the tool is s w itched off and the
battery cartridge is removed from the tool.
Place the tool upside down, and then remove the
6.
burrs from the shear blades with the file.
Fig.37: 1. F ile
Set the angle of the file to 4 , and grind the lower
7.
blade from directions with the file.
8. R eturn t h e tool to normal position, an d t h en
remove the burrs from the shear blades with the file.
Attach the branch catcher by tightening the screw.
9.
Grease lubrication
Interval of lubrication: Every 100 operating hours
Remove screws, and then remove the bottom
1.
c o v er.
Fig.38: 1. S c re w 2. Bottom c o v er
2. R emo v e t h e c ap f rom t h e grease v essel, an d t h en
attach the grease vessel to the hole on the cover by
turning t h e grease v essel.
Fig.39: 1. C o v er 2. G rease v essel
Apply the grease to the tool (Approximately
3.
a guide).
4. R emo v e t h e grease v essel.
Attach the bottom cover, and then tighten
5.
s c re w s.
OPTIONAL
ACCESSORIES
CAUTION:
are recommended for use w ith your Makita tool
specified in this manual. The use of any other
a c c essories or atta c h ments mig h t present a risk o f
injury to persons. Only use accessory or attachment
f or its state d purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
C enter.
Shear blade assembly
Shear blade cover
• C h ip re c ei v er
• G rease v essel
Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
g as
15 ENGLISH
These accessories or attachments