Genesis GLSDF36A Manual Del Operario página 8

UNPACKING AND CoNTeNT
iMPORTANT:
faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.
CONTENTS IN PACKAGE:
Description
Screwdriver
Charging adaptor
Screw Driver Bits
Operator's Manual
OPERATiON
WARNiNG:
important safety warning and instructions before using this tool.
WARNiNG:
assembly, adjustments or changing accessories.
CHARGING THE TOOL
:
NOTE
Always check that the power supply corresponds to the voltage on the ratings
1. Connect the charging adaptor to charging port (4-fIg 1)
2. Plug the adaptor into a power source.
3. Battery power indicator light: reD light illuminates when the tool is charging. The charger will automatically stop
charging when the battery is fully charged. reD light will be off when the charging is completed.
:
NOTE
It takes 3-5 hours to charge up a completely discharged battery.
SCREWDRIVER SWITCH ACTION
• Keep pressure on the left side of the Screwdriver Switch (2-fIg 1) to turn the screwdriver on counterclockwise.
• Keep pressure on the right side of switch to turn the screwdriver on clockwise.
• Release the pressure on the switch to stop the screwdriver.
LED WORK LIGHT
your tool has a built-in LeD work light (6-fIg 1) to illuminate the work area. When you turn on the screwdriver, the
work light will automatically turn on.
HEX BIT HOLDER
the tool is equipped with 1/4" Hex Magnetic Bit Holder, (1-fIg 1) that accepts standard 1/4" Hexagonal shank
accessories.
Simply insert the screwdriver bit into the bit holder. The magnetic plate inside of the bit holder will keep the bit
from falling off.
Due to modern mass production techniques, it is unlikely the tool is
QTY
1
1
2
1
T
o reduce the risk of serious personal injuries, read and follow all
Always place the switch in the locked or off position before any
Screwdriver/Flashlight 3.6V
Operator's Manual
plate.
GLSDF36A