Publicidad
6. OPERATION
Selecting the speed
With the speed controller, the rate of oscillation can be selected (also during operation).
Rotate the speed controller to choose the suitable speed.
The optimum speed depends on the material and should be determined by carrying out a
practical test.
Stage 1: slow
Stage 6: quick
Switch on and o
Hold the tool rmly to control the twisting of the tool.
To prolong the life of the tool never overload it.
WARNING: Before plugging the tool into the power point always
checks that the trigger switch work properly.
Switch the sander on by push the "I" mark on the on/o switch.
To turn o the sander, push the "O" mark.
Sanding
The sander can be used for most sanding operations on materials such as wood, plastic,
metal and painted surfaces.
WARNING : Don't use this machine on plaster.
Wear safety goggles and dust mask.
Where possible, secure smaller workpiece to prevent them from moving under the sander.
Lower the sander in contact with the workpiece without pressure and then start the sander.
Move the sander slowly over the surface of the workpiece in a circular or curved motion with
an even, moderate pressure.
If there are still scratches on your work after sanding, try either of the following:
- Go back to a coarser grit and sand the marks out before recommencing with the original
choice or,
- Try using new sanding sheet of the same grit to eliminate the unwanted marks before
progressing to a ner grit and nishing the job.
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
175
Publicidad
