Basic Connection - Ama 3 Manual Del Usuario

1. INSTALLATION
To open the AMA, see fig. 4 on the backside of this manual: Unscrew the 4 screws, hold the rubber seal
(A) and slide the housing (B) from the seal.
Attention! Only use a SIM-card with a removed password (to initialize through a GSM-cell
phone). Place the SIM-card into the right position.
To activate the SIM-card = check if you can make a phone call with the SIM-card.
When removing the SIM-card from the AMA3, please ensure to remove the battery and the wiring loom
fuse first. After replacement of the SIM-card, you need to plug in the battery and the wiring loom fuse
again. Please make sure that the motorcycle battery is in a good condition and completely charged
before installing an AMA device. We recommend the use of a trickle charger to keep the battery in a
good condition. If you choose for an Optimate4, you make a good choise.
2. CONNECTIONS

Basic connection:

Red: + 12 Volt
Black: - Ground
Blue: + 15 (+ 12 V after ignition)
White (optional): + 12V OUT (output for buzzer (pic.3) or relay interface,(max. 0,5A)
Green (optional): Auxilary input. Negative triggered according to the programming.
Yellow (optional): for push button (pic.2)
The various connection options are available for download on our website.
You can find pic. 1,2,3 and 4 on the backside of this manual.
Connect the red wire to the + 12 V (battery).
Connect the black wire to a good ground (battery).
Connect the blue wire to the + 12 V after ignition (+15V).
Plug in the internal battery after connecting the power supply. The AMA3 needs the battery
power to be able to connect to the GSM-network. The CHARGE LED (pic. 1) will burn when the back-
up battery is loading.
The initial operation of the proposed procedure can last about 2 minutes to control
all the functions and connect to the GSM-network.
The STATUS LED (pic. 1) on the PCB will blink every 5 seconds if the
AMA3 is connected to the network. If the STATUS LED blinks every second, it means
that no GSM-network connection has been made.
The AMA3 will indicate the signal strength through the buzzer each time the ignition is switched off.
F.e.: signal 3 = 3 x buzzer signals (0 buzzer signals = no signal, 5 buzzer signals = best signal)
20