Ama 3 Manual Del Usuario página 22

SMS MESSAGES SENDING AND RECEIVING
The PDST LED will blink 3 times as soon as the AMA3 receives the message.
After about 45 seconds the PDST LED will power on and off twice, followed by a steady burning during
5 seconds to indicate the message has been sent. If not, please check your
SMS, SIM-card or password and try again.
2.1. WHICH CELL PHONE WILL RECEIVE THE SMS MESSAGE?
After receiving the GSM-network signal, please program your cell phone number in the AMA3.
The cell phone number of the user is f.e.: 0123/456789
Send the following message to the AMA3: A1111+xx123456789.
A = stands for ALARM
1111 = stands for default password
+xx = stands for the international dialing code
123456789 = stands for the cell phone number of the receiver
Do not enter any spaces before or in your message. After about 45 seconds the AMA3 will send an
SMS message to the input dialing numbers to confirm:
AMA3 R5.01
PW= 1111
TEL=+xx123456789
2.2. PERSONAL PASSWORD
Desired personal password f.e.: 1234
Send the following message to the AMA3 (this could be digits or caracters) : P11111234
P = stands for PASSWORD
1111 = stands for default password
1234 = stands for a new password
Do not enter any spaces before or in your message. After about 45 seconds the AMA3 will send a SMS
message to the input dialing numbers to confirm:
AMA3 R5.01
PW= 1234
TEL=+xx123456789
2.3. FUNCTIONS AND DEFAULT VALUES
Send the following message depending on the programming: Fxxxxy=z
F = stands for FUNCTION
xxxx = stands for default password
y = stands for desired function from 1 to 5
z = stands for value 0 to z depending on the function
Do not enter any spaces before or in your message. After about 45 seconds the AMA3 will send a SMS
message to confirm:
AMA3 R5.01
PROG=0,2,7,2,3 (function 1,2,3,4 en 5)
21