Draining Tanks - Bosch CET8-15W Instrucciones De Funcionamiento

2. Pull coupler on quick connect body back to
release quick connect plug on hose.

DrAINING TANkS

1. Place the compressor on a level surface.
ensure that the compressor is on
WARNING
a level surface. If compressor is
not level, water will not drain from tanks causing
corrosion, which may cause the tanks to burst.
2. If pressure is greater than 20 psi, use safety
relief valve to reduce tank pressure.
3. Ensure that no personnel are in the drain
Maintenance
WARNING
unauthorized
result in misplacing of the internal components
which could cause
recommend that all compressor service be
performed by a BOSCH factory service center or
authorized BOSCH service station.
Your air compressor requires periodic mainte-
nance according to the maintenance schedule
outlined on the next page, in order to keep your
compressor in peak condition.
Use a soapy water solution to inspect compres-
sor for leaks. If leaks are found in the compressor
pump, air tanks or tubing, replace compressor
immediately. Never attempt repair leaks, weld or
make modifications to the air tank or other fluid
confining parts as there is a risk of bursting.
To check the air filter, unscrew the air filter from
the compressor and visually inspect. If the filter
appears to be clogged, replace the filter. After in-
spection screw the air filter back on the compres-
sor.
To Change Oil:
. Make sure the pump is cool to avoid burn risk.
2. Prepare a suitable container to capture the oil
from the crankcase.
MAINTENANCE
performed
personnel
serious hazard.
Fig. 9
SerVICe
OPERATION
discharge area behind compressor.
WARNING
propel dust and debris at high speed. Compres-
sor air from the compressor can contain water,
oil, metal particles, or other contaminants which
can cause serious injury.
. Turn drain valve on control panel 90°
counterclockwise. When empty, close valve.
WARNING
tanks. Such precautionary measures reduce the
risk of injury.
by 3. Remove crankcase drain plug (A) and allow
may
used oil to drain in the container.
. Replace drain plug.
We
5. Return oil to recycling center or dispose of in
accordance with local regulations.
6. Remove oil filler knob (B).
7. Refill crankcase with fresh oil. Fill oil until it reads
the middle of the oil sight gauge.
B
8. Replace oil filler knob.
Contact your BOSCH service center for instruc-
tions and user replaceable parts. For all other re-
pairs contact your BOSCH service center.
WARNING
portion of the tool since internal components
may be misplaced or safety components may
be improperly mounted. Certain cleaning agents
Do not direct air stream at people
or animals. High pressure air can
Do not open drain valve with
pressure greater than 20 psi in
Fig. 10
CleANING
When cleaning a compressor be
careful not to disassemble any
A