Bosch CET8-15W Instrucciones De Funcionamiento página 16

Motor will not run

TROUBLE SHOOTING
• Check valve restricted
• Motor overload protection
switch has tripped
• Extension cord is wrong length
or gauge
• Loose electrical connections
• Possible defective motor or
starting capacitor
• Paint spray on internal motor
parts.
• Fuse blown, circuit breaker
tripped
• Tank pressure exceeds pres-
sure switch cut-in pressure
• Pressure release valve on pres-
sure switch has not unloaded
head pressure
• Remove, clean or replace
• See Motor Overload under Features.
• Check proper gauge wire and cord length.
See Extension Cords under pg. .
• Contact a Bosch factory service center or
a Bosch authorized service center.
• Contact a Bosch factory service center or
a Bosch authorized service center.
• Contact a Bosch factory service center or
a Bosch authorized service center. Do not
operate the compressor in the paint spray
area. See flammable vapor warning.
. Check fuse box for blown fuse and replace
as necessary. Reset circuit breaker. Do not
use a fuse or circuit breaker with higher
rating than that specified for your particu-
lar branch circuit.
2. Check for proper fuse. Use only a time de-
lay fuse.
3. Check for low voltage conditions and/or
proper extension cord.
. Disconnect the other electrical appliances
from circuit or operate the compressor on
its own branch circuit.
• Motor will start automatically when tank
pressure drops below cut-in pressure of
pressure switch.
• Set the On/Off switch to OFF. If the valve
does not open, replace switch. Contact a
Bosch factory service center or a Bosch
authorized service center.