Temperature Setting - Beper 50.050 Manual De Instrucciones

Steam generator Use instructions

TEMPERATURE SETTING

Always consult the labels of washing and sharpening inside clothing.
If you cannot find them and if you do not know the type of fabric, please refer to the table below:
Kind of fabric
AcetateAcrylicNylon
PolyesterViscose
Silk
WoolLight cot-
tonLight linen
Cotton Thin linen
Starched fabrics
Linen
The numbers of points on the thermostat knob (10) indicate the lower (•) and higher (•••) temperature.
Before using the iron, always make sure that the temperature of iron is adapted to the type of fabric: wool with
wool, cotton with cotton, etc.
The iron heats quickly and cools slowly; thus always start with clothing which requires a low temperature (like
synthetic fabrics) and always progress with the highest temperatures.
When the cloth is made of several fabrics, set the temperature for the most delicate fabric.
If you do not know the type of fabric we recommend to iron the internal parts of clothing, from lowest temperature,
and then finding the temperature more adapted. If clothing becomes "brilliant", stop immediately in order to not
damage it. Then start to iron it on the back.
N.B. pay attention to the symbol
AUTO SHUTOFF FUCNTION:
If you place the iron on the base in 15+/-1 minutes, the power will be automatically shut off. The switch light (6)
will be twinkling to indicate the power is auto off. Once you press NO.12 or NO.18 to use again, the iron will be
re-connected the power automatically.
WATER EMPTY INDICATION FUNCTION:
Once the water tank is empty, the light of NO.8 will be turned on until the water tank is filled with water, the light
will be off.
Temperature Ironing instructions
position
Ironing without steam. Follow the instructions indicated
on clothing. This type of fabric requires a very soft ironing.
Ironing without steam.Ironing on the back of clothing. Se-
lect the lowest temperature for ironing mix fabric.
Ironing without steam.Ironing on the back of clothing.
Ironing with steam.Ironing on the back of clothing. Put a
wet cloth on the fabric in order to avoid the "brilliant "ef-
fect.
Ironing with steam.Moist the fabrics before ironing. The
thicker and starched fabrics must be a little wetter than
the light fabrics which can be ironed directly: the dark co-
lours and clothing with embroidery must be ironed on the
back.
Ironing with vapour.Use a lot of steam and iron the dark
clothing on the back in order to avoid the "brilliant "effect.
: the cloth or fabric must not be ironed.
10