Beper 50.050 Manual De Instrucciones página 9

EN
Steam generator Use instructions
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without expe-
rience or technical ability to use the appliance if they are not properly
watched over. Close supervision is necessary when any appliance
used by or near children.
Make sure that children do not play with this appliance.
If you decide not to use the appliance any longer, make it unservice-
able by simply cutting the supply cable after disconnecting the plug
from the socket.
ALSO MAKE ANY DANGEROUS PARTS UNSERVICE-
ABLE, ESPECIALLY FOR CHILDREN WHO COULD
PLAY WITH THE APPLIANCE.
PARTS AND ACCESSORIES Fig.A
1-Machine
2- Water tank
3-Filler cap
4- Base
5- On/Off switch
6- Water light indicator
7- Power cord
8- Steam adjustment
9- Light indicator
10- Temperature knob
11- Steam button
12-Anticalc filter
When used for the first time, clean the iron with a cloth (without any detergent).
a) Supply tap water or demineralized water. The water tank capacity is 1.5 liters. Fill the water tank with 1500 ml
and be careful about not filling it too much. If some water comes out or if the water tank is too full, empty slightly
the tank and dry well the device.
b) Insert the plug in the wall outlet and turn on switch.
Select desired temperature with the thermostat knob When the thermostat pilot lamp (9) turn off, that means the
temperature is reached and the iron ready to use.
Note: During the whole operating time, the iron operating light indicator will go on and off in erratic intervals, this
is normal.
c) To make the steam jet come out, press the steam button (8). Release the steam button when steam is no
longer necessary.
If the steam jet becomes lower when ironing, that means the tank is empty
9