Functional Description; Attaching/Removing Accessories - Milwaukee M-SPECTOR Manual Del Operador

Federal
Communications
Commission
interference in which case the user may be required
to take adequate measures.
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment gener-
ates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instruction manual, may cause harmful interference
to radio communications. Operation of this equip-
ment in a residential area is likely to cause harmful
interference in which case the user will be required
to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.

FUNCTIONAL DESCRIPTION

This is a class
WARNING
A product. In
a domestic environment this
product may cause radio
2
3
4
5
6
7
1. Camera
2. Camera LEDs
3. Cable
4. LCD
5. Low battery indicator
6. Power button
7. LED brightness increase/
decrease buttons
Loading/Changing the Battery
1. Using a flat screwdriver, rotate the battery door
lock to the unlocked position and open the battery
door.
2. Connect one (1) 9V battery to the connector
block. Install battery according to polarity (+ / –)
diagrams. Fit the battery into the compartment.
3. Close the battery door. Turn the battery door lock
1
to the locked position.

Attaching/Removing Accessories

To attach an accessory, hook the two front hooks
over the front of the camera. Press the clip over the
back end of the camera to snap it into the detents.
To remove, pull up on the clip and then unhook the
accessory.
WARNING
with side shields.
Press the Power button to turn the tool on. Press and
hold the Power button to turn the tool off.
The tool will shut off automatically if unused for 5
minutes. To reset, press the Power button again.
Low Battery Indicator
Replace the battery soon when the low battery
indicator lights.
The camera LEDs can be adjusted to 4 levels of
brightness and turned off. Press the camera LED
brightness increase and decrease buttons to change
the level of brightness or turn it off.
WARNING
age, always check the work area before beginning
a job. Do not allow cable to contact electrical,
chemical, or moving hazards.
3
ASSEMBLY
OPERATION
To reduce the risk of injury, always
wear safety goggles or glasses
Turning On/Off
Sleep Mode
Camera LED
To reduce the risk of explosion,
electric shock and property dam-