HumanTechnik Signolux SoundMonitor Instrucciones De Servicio página 13

Transmission indicator
This LED indicates any outgoing
transmission with a red light.
Function buttons
The correct functioning of the »sound-
monitor« can be tested with any of the
three function buttons. After pairing
the »soundmonitor« with at least one
receiver, the transmission and the trig-
gered event indication on the receiver
can be tested by pressing one of the-
se buttons.
The function buttons also serve to
teach the »soundmonitor« the sounds
it will react to.
Setup
1. Choosing the best position
The »soundmonitor« scans and ana-
lyses the noises in its vicinity for the
patterns of the sounds it has been
taught.
In order to assist this function, the
»soundmonitor« should be placed as
close as possible to the sound source
it is supposed to identify (for example
placed on a wall underneath the door
bell).
In order to ensure the largest possible
transmission range, please note the
following recommendations:
- The transmitter should not be
placed close to interference-emitting
devices such as TV sets, computer
screens and mobile phones.
- The transmitter should not be placed
on metal objects or surfaces due to
the radio-shielding effect of the
metal.
2. Teaching the desired sounds
Switch the »soundmonitor« on by
shifting the On/Off switch to the »ON«
position.
To teach a new sound, press and hold
one of the function buttons, located
on the upper face of the device, for 2
to 3 seconds until the adjacent LED of
the button starts to blink.
Trigger the desired sound on the
sound source. The sound should have
a length of one to two seconds.
During the recording, the microphone
status indicator must be lit constantly!
The function button LED will light up
and go out after the sound has been
recorded.
The new sound has been taught. The
other two function buttons can also be
programmed as described above.
Please note:
Every recognised sound is indicated
by the same event icon on the recei-
vers.
English 13