Removing / Fitting Onto Kss Rail; Service And Maintenance; Storage; Troubleshooting - Mafell MF 26 cc Manual De Instrucciones


Set the required milling depth and machine the
workpiece.

5.14 Removing / fitting onto KSS rail

Remove:

Slide the machine forward on the rail by 2-3 cm
(25/32 – 1 3/16 in.).

Actuate the ratchet 41 (Fig. 5) and pull the
machine to the rear out of the guide rail.
Attaching:

Place the machine onto the guide rail in the rear
guide rail area such that the groove 24 (Fig. 6)
on the front of the base plate agrees with the
spring of the guide rail (overlap on the left-hand
base plate side approx. 5 - 10 mm, 13/64 –
25/64 in.).

Slide the machine forward until the ratchet
engages behind the base plate.
7

Troubleshooting

Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Machine cannot be switched on
Machine stops while cutting is in
process
Tool jams when advancing the
machine
Danger
Determining the causes for existing defects and eliminating these always
requires increased attention and caution. Pull the mains plug beforehand!
Cause
No mains voltage
Mains fuse defective
Carbon brushes worn
Mains failure
Machine overloaded
Feed rate too fast
Blunt tool
Tension in the workpiece
Poor machine guidance
Uneven workpiece surface
-31-
6

Service and maintenance

Danger
Pull the power plug during all
service work.
MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.

6.1 Storage

If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
Elimination
Check power supply
Replace fuse
Take the machine to a MAFELL
customer service shop
Check mains back-up fuses
Reduce feed speed
Reduce feed speed
Release the switch immediately.
Remove machine from the
workpiece and exchange tool
Use parallel stop
Straighten the surface