Assembling And Disassembling - Orangemarine INOVANEX LC air 200 Manual De Usuario

1.2 Equipment
Standard equipment:
1. Two aluminum oars in two parts
2. Seat in marine plywood or inflatable (on the Inovanex range)
3. Foot pump
4. Reparation kit
5. Transportation bag
Optional equipment (available on www.orange-marine.com):
1. Under-seat storage bag
2. Bow bag
3. Additional oar
1.3 Environment temperature
Sun exposition: the PVC inflatable boats are conceived for being used in temperate areas.
Furthermore, they must not be exposed to sun for long periods: this could cause a
degradation of quality and color of PVC.

2. ASSEMBLING AND DISASSEMBLING

2.1 Assembling
a. General procedure
1. Remove every sharp object form the place in where the boat is going to be assembled
and inflated.
2. Unfold and spread the boat out flat.
3. Start by inflating the boat half of the way full using the pump.
4. Assemble the floor following the instructions on the floorboards.
5. Assemble the seat.
6. Complete the inflation.
7. Control the valves in order to verify the presence of leaks.
8. Make sure that all the basic equipment is on board.
9. Do not inflate the quill before assembling the floor.
Recommended pressure for tubes: 0.25 bars
Recommended pressure for keel: 0.20 bars
Recommended pressure for inflatable floor: 1 bar.