Hultafors XL2 Instrucciones De Uso página 20

Turn the device towards point B until the vertical beam has been displaced
by 5 m. Measure the distance E. If the distance E does not exceed 5 mm,
the accuracy is within the tolerance. In the event of significant deviations,
consult an authorised service provider (fig. 4)..
Verticality beam (between two end points)
To achieve optimum results, mount the instrument on a levelling platform that is
fastened between the floor and the ceiling (e.g. clamp column).
Insert the instrument in the holder and fasten it to the levelling platform.
Then set up the instrument at a distance of roughly 5 m from a wall. Lower
the device as near as possible to the floor.
B
M1
E
A
Raise the instrument towards point B until the horizontal beam has been
displaced by 2.5 m. Measure the distance E. If the distance E does not
exceed 1.25 mm, the accuracy is within the tolerance. In the event of signifi-
cant deviations, consult an authorised service provider.
GB
Press both buttons for the vertical and
horizontal planes to project a laser beam
on the wall. Mark the point A at the inter-
section point of the beams and mark point
M1 on the plumb line, 1.25 m from point
A (fig. 5).
22